Operation CHARM: Car repair manuals for everyone.

Accelerator Pedal: Service and Repair

ACCELERATOR PEDAL





Lightly move pedal pad in lateral the direction to ensure pedal deflection is in specified range.

Deflection of accelerator pedal:
Service limit
5.0 mm (0.197 in) or less


CAUTION: It excessive deflection is noted, replace bushing and clip with new ones.

3. STOP LIGHT SWITCH





If stop light switch does not operate properly (or if it does not stop at the specified position), replace with a new one.





Specified position: L
2.8+ 1.5/0 mm (0.110 +0.059/0 in)


ASSEMBLY
BRAKE AND CLUTCH PEDAL
1) Attach stop light switch, etc. to pedal bracket temporarily.
2) Clean inside of bores of clutch pedal and brake pedal, apply grease, and set bushings into bores.
3) Align bores of pedal bracket, clutch pedal and brake pedal, attach brake pedal return spring and clutch pedal effort reducing spring (vehicle with hill holder), and then install pedal bolt.

Tightening torque:
T2: 29 ± 7 kg.m (3.0 ± 0.7 kg-m, 21.7 ± 5.1 ft-lb)


NOTE: Clean up inside of bushings and apply grease before installing spacer.

4) Set brake pedal position by adjusting position of stop light switch.

Pedal position: L
125.9 mm (4.96 in)


Tightening torque:
T1: 8 ± 2 N.m (0.8 ± 0.2 kg-m, 5.8 ± 1.4 ft-lb)


ACCELERATOR PEDAL
Clean and apply grease to spacer and inside bore of accelerator pedal. Install accelerator pedal onto pedal bracket.

INSTALLATION
1) Installation is in the reverse order of removal procedures.

CAUTION:
- Be careful not to bend clutch cable too much.
- Never fail to cover outer cable end with boot.
- Be careful not to kink accelerator cable.
- Make sure that holder and casing cap are securely connected.

2) Adjust clutch pedal
3) Adjustment after pedal installation

ADJUSTMENT
CLUTCH PEDAL
1) Turn cruise control clutch switch lock nuts until clutch pedal full stroke length is within specifications.











CAUTION: Do not attempt to turn clutch switch to adjust clutch pedal full stroke length.

NOTE: If lock nuts cannot adjust clutch pedal full stroke length to specifications, turn master cylinder push rod to adjust it.

Specified clutch pedal full stroke: A
130 - 135 mm (5.11 - 5.31 in)


Tightening torque (Clutch switch lock nut):
8 ± 2 N.m (0.8 ± 0.2 kg-m, 5.8 ± 1.4 ft.lb)


2) Turn master cylinder push rod so that clevis pin moves to the left and then to the right. The clevis pin must move without resistance while it is rattling.

Tightening torque (Push rod lock nut):
0.2 N.m (0.8 ± 0.2 kg-m, 5.8 ± 1.4 ft-lb)


3) Depress and release clutch pedal 2 to 3 times to ensure that clutch pedal and release fork operate smoothly. If clutch pedal and release fork do not operate smoothly, bleed air from clutch hydraulic system.
4) Measure clutch pedal full stroke length again to ensure that it is within specifications. If it is not, repeat adjustment procedures again from the beginning.