Operation CHARM: Car repair manuals for everyone.

Intake Manifold: Service and Repair



Inlet Manifold, throttle housing and fuel injection rail





1 Drain the coolant.

2 Disconnect the negative (-) battery lead and cover the terminal pole on the battery.





3 Disconnect the rubber elbow from between the throttle housing and air mass meter.





4 unplug the electrical connector from the throttle-position sensor.





5 Disconnect the crankcase breather hose from the throttle housing.






6 Disconnect the cruise control vacuum hose from the throttle housing.





7 Disconnect the AIC-valve hose from the throttle housing.





8 Disconnect the throttle-housing preheater hoses.





9 Disconnect the throttle cable from the throttle linkage (Automatics: and the kickdown cable).





10 Disconnect the fuel-pressure regulator vacuum hose and the small-bore crankcase breather hose from the inlet manifold.





11 Disconnect the vacuum hose for the charcoal canister from the inlet manifold.





12 Remove the two bolts in the sides of the top of the inlet manifold (slacken off the lower ones).





13 Remove the bracket for the dipstick tube and the remaining bolts in the top of the inlet manifold.





14 Unplug the connector from the AIC valve and lift off the top of the inlet manifold.

15 Disconnect the electrical leads from the following:





- Injectors (leads are labelled with cylinder number)





- The two earthing points on the inlet manifold (note their positions)





- The temperature sensor

16 Release the wiring loom from the clips under the inlet manifold.

17 Remove the throttle-cable bracket from the inlet manifold.





18 Clean the surrounding surfaces and disconnect the fuel hoses from the fuel-injection rail.





19 Undo the bolts securing the steady bars to the inlet manifold.





20 Remove the remaining bolts in the lower half of the inlet manifold securing it to the cylinder head.





21 Lift off the lower section of the inlet manifold complete with fuel-injection rail.

To fit

Fit new gaskets between the lower section of the inlet manifold and the cylinder head, and between the two sections of the manifold.

Refit in the reverse order.