Operation CHARM: Car repair manuals for everyone.

Fuel Pick-Up Assembly - Conversion Procedure

84saab02

SUBJECT: INTRODUCTION OF NEW FUEL PICK-UP

ASSEMBLY - MID-1984 900 PRODUCTION

ISSUE: 07/84-695
FILE IN S.I. MANUAL:

VOLUME: I

SECTION: 2

PAGE: 166
During mid-M84 production and beginning with VIN Serial Nos. E1021336 and E2009858, a new fuel Pick-up assembly was introduced which replaces the present "bow tie" pick-up screen. The new pick-up (P/N 93-86-491) reduces the chance that fuel delivery could be impeded by improper installation of the fuel pump assembly.

If repairs are necessary to cars equipped with the "bow tie" type (P/N 93-49-689) individual components may be replaced until current parts supplies are depleted. In order to convert the new fuel pick-up (P/N 93-86-491), please refer to the following conversion details.

Conversion Procedure (If Necessary)


NO SMOKING OR OPEN FLAME!



1. Disconnect battery terminals when working with fuel delivery systems.

2. Remove and discard "bow tie" screen, clamp, pre-pump O-ring and the spacer at the bottom of the fuel canister. (Do not lose the screw for the spacer, it is to be reinstalled.)

The canister is supported by the new pick-up assembly, making the spacer (P/N 93-65-701) and washer (P/N 75-11-678) unnecessary.



3. Fit the new fuel pick-up assembly (P/N 93-86-491) to the pre-pump and bolt the entire assembly to the fuel canister using the existing bolts. Note that the O-ring (P/N 93-49-663) is no longer used at the pre-pump-to-canister seal. The new fuel pick-up provides better support for the pre-pump and the O-ring is no longer necessary.

Re-fit the mounting screw for the spacer (P/N 93-65-701) but do not include the spacer.

Failure to re-fit the screw will prevent the pressurization of the fuel inside the canister and hotweather/low fuel level delivery problems could result.

4. Re-install the pump assembly into the tank and re-connect the battery terminals.