Operation CHARM: Car repair manuals for everyone.

Removing and Installing Drive Belt



Removing and installing drive belt

Preliminary work

1. Put protective covers in the passenger compartment.
2. Remove rear wall cover.

Removal

Removing drive belt

Drive belt routing (view on removed engine):





Drive belt on engine (view with engine removed)

1 - Drive belt

2 - Generator pulley

3 - Power-steering pump pulley (plastic)

4 - Air-conditioning compressor pulley

5 - Crankshaft vibration damper

6 - Coolant pump pulley

7 - Belt tensioner tensioning roller

Notice
Drive belt removed incorrectly
^ Risk of damage to drive belt

-> Only remove the drive belt when it is cold.

-> Replace damaged drive belt.

Information
^ Mark running direction of drive belt with a colored pen.
^ Even minor damage means that the drive belt must be replaced (even if the maintenance interval has not expired).
^ The drive belt can be cut if it has to be replaced.

1. Slacken the drive belt.
1.1. Fit a ring wrench (a/f 30) -2- on the hexagon -1- on the tensioner, turn it clockwise as far as it will go and hold it at that position.





Relieving drive belt

1.2. Remove drive belt from the pulley on the generator -arrow- .
1.3. Carefully allow the tensioning roller to slide back to its original position.
2. Feed the drive belt -1- out between the engine bracket and vibration damper -2- .





Drive belt on vibration damper

3. Feed out the drive belt on the various pulleys.

1 - Drive belt

2 - Generator pulley





Drive belt on pulley

3 - Coolant pump pulley

4 - Tensioning roller

5 - Hydraulic pump pulley (plastic)

4. Take off the drive belt -1- .
4.1. If you intend to re-install the drive belt, check it carefully for signs of damage on both running tracks.





Drive belt through maintenance opening

Information
^ Check for foreign objects in the grooves of the pulley.

5. Check pulley for damage.

Installation

Installing drive belt

Drive belt routing (view on removed engine):





Drive belt routing

1 - Drive belt

2 - Generator pulley

3 - Power-steering pump pulley (plastic)

4 - Air-conditioning compressor pulley

5 - Crankshaft vibration damper

6 - Coolant pump pulley

7 - Belt tensioner tensioning roller

1. Guide in the drive belt with the flat side between the engine bracket and vibration damper and position it on the grooves.





Drive belt on vibration damper

2. Fit the drive belt onto the other pulleys in accordance with the belt threading course.

1 - Drive belt

2 - Generator pulley

3 - Coolant pump pulley

4 - Tensioning roller

5 - Hydraulic pump pulley (plastic)





Drive belt on pulley

2.1. Fit drive belt on the tensioning roller
3. Fit drive belt.
3.1. Fit a ring wrench (a/f 30) -2- on the hexagon -1- on the tensioner, turn it clockwise as far as it will go and hold it at that position.
3.2. Slide the drive belt onto the tensioning roller.
3.3. Let the tensioner slide back slowly into tensioning position (anti-clockwise).





Relieving drive belt

4. Check that all pulleys and the tensioning roller are installed at the correct position.
4.1. To do this, turn the belt tensioner clockwise as far as it will go using the ring wrench -1- and hold it at this position.
4.2. Guide the drive belt clockwise over the pulley -2- for the air conditioning compressor with your hand.





Checking installation position of drive belt

Subsequent work

1. Install rear wall cover.
2. Remove protective covers in the passenger compartment.