Operation CHARM: Car repair manuals for everyone.

Procedures



276019 Removing and Installing Starter

Preliminary work

Preliminary work - starter
Disconnect battery.

Removing starter


Installation Position:




Unscrewing Fastening Nuts On Starter:






1. Remove caps from fastening nuts.

WARNING: If the battery has not been disconnected, battery voltage will be present at the leads during removal and installation.
- Risk of injury from burns and electric shock.
- Damage to electrical leads, control units and components due to accidental contact of leads with ground.
- Disconnect both battery terminals and cover the + terminal.

2. Unscrew fastening nuts -1, 2- on the starter, remove the leads and lay them to one side.


Unscrewing Fastening Screws:






3. Undo the two fastening screws -3-.
4. Remove the starter rearward from the engine, rotating the starter as necessary.

Installing starter

WARNING: If the battery has not been disconnected, battery voltage will be present at the leads during removal and installation.
- Risk of injury from burns and electric shock.
- Damage to electrical leads, control units and components due to accidental contact of leads with ground.
- Disconnect both battery terminals and cover the + terminal.

1. Insert and position starter into engine compartment, rotating it slightly aufsetzen.

The angled cable lug of terminal 50 (M6) -1- faces in driving direction after assembly.


Screwing Down Starter With Fastening Screws:






2. Insert fastening screws -3- on starter, screw into the engine housing and tighten Tightening torque 33 ftlb..


Tightening Electrical Leads To Starter:






3. Position electrical leads on the starter and tighten with fastening nuts -1, 2-. Tightening torque 13 ftlb. Tightening torque 5.0 ftlb..
4. Fit caps on fastening nuts.

Subsequent work

Subsequent work - starter
Disconnect battery.