Operation CHARM: Car repair manuals for everyone.

Electric Door Locking System - Adjusting/Troubleshooting: Overview

83porsche02

Subject:

Electric Door Locking System


Part Identifier N/A
Applies To 928/S


(Supersedes Product Circular, Grp. 57, No. 83-01)03/18/83
Group


57
Key Points

Adjusting and Troubleshooting

1980 model and later
C
Number

83-02

May 3, 1983



Electrically operated door locks replace vacuumoperated locks on 1980 models. New system uses control unit at each door that includes electric motor, locking rod and switching element. Each switching element receives current through a 4-terminal connector with designations marked 1-2-3-4.
A - to CES (central electrical system) K 2 (terminal 30, red/white)
B - to ground on steering bracket (brown)
C - to ground on front of CES "
D - key switch E - motor cutoff switch

Operating principle

When key is turned to lock door, locking rod transmits this motion to contact switching arm (D). Switching arm has a "neutral phase"; the control is activated only when the key is turned far enough to move a switching arm to next contact. When this is done, electric motor goes on and locks doors via the rod. Position of (D) now allows current to pass to the motor locking the other door. Switches (E) flip over when motors reach final positions.
Switch (D) in each door is connected to internal cutoff between (E) and motor, so both (D) switches flip over when motors reach final position. Thus, both doors can be unlocked or locked simultaneously by turning key in only one door. For safety, locking system operates only when ignition is off.

Power to system passes through side window activating relay VI, terminal 87a.