Band Apply Servo: Service and Repair
REMOVE OR DISCONNECT
^ Tool Required:
- J 35534 Piston Cover Depressor
1. Raise and suitably; support vehicle.
2. Three transaxle fluid pan bolts and install J 35534.
3. Tighten the adjustment bolt on the J 35534 until servo cover snap ring can be removed.
4. Servo cover snap ring.
5. J 35534 after slowly loosening adjustment bolt.
6. Servo cover, servo piston, springs and piston rod.
Inspect
- Intermediate servo assembly. Refer to Automatic Transaxle Diagnosis in Book 2 of 2 for inspection and diagnosis procedures.
INSTALL OR CONNECT
^ Tools Required:
- J 35534 Piston Cover Depressor
- J 36850 Transjel (tm) Transmission Assembly Lubricant
NOTICE: After making sure all parts are clean, liberally apply J 36850 to all servo parts prior to assembly. This serves to prelubricate sears and to ensure ease of assembly.
1. Piston rod, springs, piston and piston cover.
2. The J 35534 and tighten adjustment bolt until servo cover snap ring can be installed.
3. Servo cover snap ring.
4. Remove the J 35534.
5. Three transaxle fluid pan bolts.
Tighten
- Transaxle fluid pan bolts to 6 N.m (53 lb. in.).
6. Lower vehicle.
7. Refill transaxle as necessary:
A. Place vehicle on a level surface.
B. Remove fluid level indicator.
C. Add approximately 0.5 liters (0.5 qts.) of Dexron (tm) automatic transmission fluid GM P/N 12346143, or equivalent, into fluid filler tube.
D. Install fluid level indicator into fluid filler
E. Apply parking brake and block vehicle wheels.
F. With selector lever in "P" position, start engine. DO NOT race engine.
G. Run engine at idle and move selector lever through each range and return to the "P" position.
H. With engine running at idle, remove fluid level indicator from filler tube and wipe indicator off.
I. Reinsert fluid level indicator into flier tube making sure it is seated in its original position.
J. Remove the indicator and check the fluid level. The level should be between the "FULL HOT" and "LOW HOT" marks. If the level is below the "LOW HOT" mark, add fluid to bring the level to the "FULL HOT" mark. Bringing the fluid level from the "LOW HOT" mark to the "FULL HOT" mark requires 0.3 liters (0.3 qts.) of fluid. Use Dexron (tm) III automatic transmission fluid GM P/N 12346143, or equivalent.