Engine - Cold Detonation and Hot Hesitation
Number 87-6 (Gasoline)-9A Date 7/87Subject: DRIVEABILITY: HOT HESITATION/COLD DETONATION
1987 SAFARI, FIREBIRD AND GRAND PRIX MODELS WITH 5.0L LG4 ENGINE (ENGINE CODE H)
Some early passenger cars equipped with 5.0L (LG4) engines and having VIN numbers prior to those listed below may experience one or both of the following driveability conditions:
a). Detonation prior to the engine fully warming up, or;
b). Hesitation during a sharp tip-in maneuver with a fully warmed up engine (sometimes called, "pump slug").
These conditions may be improved by installation of an accelerator pump check ball spring, P/N 17069583, and the appropriate service PROM from the table below:
Applicable VIN Numbers
Model Plant Prior to VIN Number
Grand Prix Ste. Therese All
Safari Fairfax 208979 (Federal Emissions)
209228 (California Emissions)
Firebird Van Nuys 223698
Norwood 232459
Service PROM Usage Table
Safari (LG4)
Station Wgn. 2.73 Fed. Emis. 16077198
Station Wgn. 3.08 Fed. Emis. 16077194
Station Wgn. 2.73 Calif. Emis. 16077563
Station Wgn. 3.08 Calif. Emis. 16077568
Grand Prix (LG4)
4 Spd. Auto. 2.41 Axle Fed. Emis. 16077306
4 Spd. Auto. 3.08 Axle Fed. Emis. 16077317
3 Spd. Auto. 2.41, 2.73 Axle Fed. Emis. 16077333
4 Spd. Auto. 2.41 Axle Calif. Emis. 16077321
4 Spd. Auto. 3.08 Axle Calif. Emis. 16077325
3 Spd. Auto. 2.41, 2.73 Axle Calif. Emis. 16077329
Firebird (LG4)
4 Auto. 2.73 Axle Fed. Emis. P195/P215 16077174
Tires
4 Auto. 2.73 Axle Fed. Emis. P245 Tires 16077178
4 Auto. 2.73 Axle Calif. Emis. P195/P215 16077185
Tires
4 Auto. 2.73 Axle Calif. Emis. P245 Tires 16077189
Service Procedure:
1. Disconnect negative battery cable.
2. Install appropriate service PROM.
3. Remove air cleaner.
4. Remove air horn. (Refer to Section 6C1 of Service Manual if details of disassembly are needed).
5. Remove solenoid adjusting screw plug from air horn.
6. Remove solenoid plunger, air horn gasket, pump assembly, metering rods and float bowl insert.
7. Count and record the number of turns to the solenoid adjusting screw required to lightly bottom the mixture control solenoid.
8. Remove the mixture control solenoid assembly.
9. Remove float and needle.
ILLUSTRATION:
10. Remove pump discharge plug.
11. Install accelerator pump check ball spring, P/N 17069583. SEE ILLUSTRATION
12. Reinstall pump discharge plug.
13. Reinstall float and needle. (Hook needle pull clip over float lever crossbar facing seat. DO NOT hook through holes in float lever).
14. Reinstall mixture control solenoid.
15. Reinstall solenoid adjusting screw and turn it to lightly bottom solenoid, then back out the number of turns counted during disassembly.
16. Reinstall float bowl insert, metering rods, pump assembly, air horn gasket and solenoid plunger.
17. Reinstall air horn.
18. Reinstall solenoid adjusting screw plug.
19. Reinstall air cleaner.
20. Reconnect negative battery cable.
Warranty Information:
Labor Operation: T1217
Labor Time : .9 Hour Safari and Grand Prix Models
1.1 Hour Firebird Models