Generator - CS-144 Service Parts
Number 87-6(Gasoline)-8 Date 12/86Subject: CS-144 GENERATOR SERVICE PARTS
1987 BONNEVILLE MODELS
The CS-144 generator used on the above listed models was originally serviced only as a complete assembly. Service parts for the CS-144 generator are now available through GMWDD, and a listing of parts unique to these generators is provided.
For diagnosis of the generator, refer to Section 6D of the Service Manual.
The CS-144 internal parts are similar to earlier models, but are electrically different.. Therefore, only service parts listed for the CS-144 should be used. There is also a basic design and assembly difference in the slip ring end bearing as compared to past models. This difference is as follows:
GENERATOR ASSEMBLY:
Slip Ring End Bearing Installation:
A new slip ring end bearing (Part Number 1989711) must be installed whenever the rotor is separated from the slip ring end frame.
1. Install the slip ring end bearing onto the rotor shaft by pressing on the inner race until the stop is reached (See Illustration).
2. Guide the bearing into the slip ring end cavity being careful not to deform the tolerance rings (plastic rings) that are part of the outer race of the bearing.
3. Install the four thru-bolts from the slip ring end frame to the drive end frame.
Warranty Information:
For warranty purposes, use Labor Operation Number J4080, and the appropriate ADD condition when repairing the generator. When replacing the generator with a remanufactured unit, use Labor Operation Number J4100.
CS 144 - SERVICE PART NUMBERS
1987 BONNEVILLE
QUANTITY 3.8L
DESCRIPTION REQUIRED 108 AMP
Original Equipment Generator 1101250
Remanufactured Generator 10463033
*Regulator 1 1116411
*Rotor Assembly 1 1989599
*Stator Assembly 1 1989705
*Frame - S.R.E. 1 1989706
*Ball Bearing - S.R.E. 1 1989711
*Rectifier Bridge - Pos. 1 1989774
*Nut - Rectifier Bridge 3 453996
*Connector - From Rect. Bridge to Reg. 1 10497789
Screw & Washer - Rect. Bridge Attachment 2 1988971
*Brush Holder & Brush Assy. 1 1989702
*Spring - Brush 2 1989659
Screw - Brush Holder Attachment (Ground) 1 1894586
*Screw - Regulator Attachment (Insulated) 1 1989699
Terminal Package - Battery 1 1975471
*Capacitor 1 1989703
Screw - Capacitor & Rect. Bridge 1 1988970
Attachment
*Frame - D.E. 1 1989601
Ball Bearing - D.E. 1 908419
Plate - Ball Bearing Retain. - D.E. 1 1977674
Screw - Ball Bearing Retain. Plate 3 1975736
Attachment
Collar - Shaft - Outside - D.E. 1 1985999
Collar - Shaft - Inside - D.E. 1 1986000
Collar - Shaft Between Fan & Pulley 1 1978064
Nut - Shaft - D.E. 1 1915172
Lockwasher - Shaft Nut - D.E. 1 1941978
*Thru Bolt 4 1989690
Pulley 1 1985964
Fan 1 1978026
* New Part S.R.E. = Slip Ring End D.E. = Drive End