Camshaft Sensor Interrupter - Broken
Number 87-6 (Gasoline)-15A Date 1/87Subject: BROKEN CAMSHAFT SENSOR INTERRUPTER (NO START - CODE 41)
1987 BONNEVILLE MODELS WITH 3.8L (VIN CODE 3) ENGINES
If a broken camshaft sensor interrupter is encountered on the above engine, the following instructions should be followed for its replacement:
I. Vehicle Odometer Registers More Than 15 Miles
^ Install new camshaft interrupter P/N 25531725.
^ Install new timing chain cover and valve P/N 12329552. The new cover has a built in thrust surface that limits forward movement of the camshaft.
^ Inspection of the camshaft for a relief hole should not be necessary.
II. Vehicle Odometer Registers Less Than 15 Miles
^ Inspect the camshaft to ensure that the oil relief hole which runs parallel to the shafts center line and from the front to the back of the shafts rear bearing journal is drilled clear through. If it is not, finish drilling the hole through the shaft. Clean the hole, remove any burrs and reinstall it.
NOTE: Inspection of the camshaft for the relief hole can be accomplished by removing the timing chain cover, intake manifold assembly and valve lifters, and then moving the camshaft forward slightly. The hole should then be readily visible from the front side of the shaft. It may be necessary to rotate it 180 degrees to view the opposite side.
^ Install a new camshaft interrupter and timing chain cover and relief valve as indicated in item I above.
Engines built after December 1, 1986, will be assembled with the new timing chain cover and interrupter and should not experience the breakage condition. Casting number on the new cover is 25531877.
Warranty Information
Labor Operation: T4200 - Replace Front Cover and 1.7 Camshaft Interrupter
Add - Inspect Camshaft For Hole 1.7
Add - Remove Camshaft and Drill Hole 2.8
Trouble Code : 92