Operation CHARM: Car repair manuals for everyone.

Clutch: Service and Repair






1. Disconnect battery ground cable.

2. On 1982-86 models, disconnect clutch cable from clutch release lever and transaxle as follows:

a. Support clutch pedal upward against bumper stop to release pawl from quadrant.

b. Disconnect cable from clutch release lever on transaxle. Use care to avoid cable from snapping toward rear of vehicle.

c. Disconnect cable from quadrant. Lift the locking pawl away from quadrant, then slide cable out on right side.

3. On 1987-88 models, remove hush panel, then disconnect clutch master cylinder push rod from clutch pedal.

4. On all models, remove transaxle as described under "Manual Transaxle, Replace."

5. Mark position of pressure plate to flywheel to aid reassembly.

6. Gradually loosen pressure plate attaching bolts until spring pressure is relieved.

7. Support pressure plate and remove mounting bolts, pressure plate and driven disc, see accompanying image.

8. Clean pressure and flywheel mounting surfaces. Inspect bearing retainer outer surface of transaxle.

9. Place driven disc in relative installed position and support with a dummy shaft.

NOTE: The driven disc is installed with the damper springs offset toward the transaxle stamped letters found on the driven disc identify the "Flywheel Side."

10. Install and gradually tighten the pressure plate to flywheel bolts. Remove dummy shaft.

11. Lubricate the release bearing outside diameter groove and the inside diameter recess with lubricant No. 1051344 or equivalent. Also lightly lubricate inputs shaft spline.

12. Install transaxle. On models equipped with hydraulic clutch system, do not move clutch lever toward flywheel until after transaxle has been installed to engine, as damage to transaxle may result.

13. On models with mechanical clutch linkage, connect clutch cable, then adjust as described under "Mechanical Clutch Linkage, Adjust."

14. On models with hydraulic clutch system, connect clutch master cylinder
push rod to clutch pedal, then install hush panel.

15. On all models, connect battery ground cable.