Windshield Washer Motor: Service and Repair
REMOVAL1. Remove reservoir Refer to Washer Reservoir Installation.
Washer Reservoir Pump:
2. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
3. Remover rubber grommet from reservoir and throw away.
INSTALLATION
1. Install a new grommet.
2. Lubricate the pump with petroleum jelly.
3. Push the pump into the grommet until fully seated.
4. Install the reservoir. Refer to Washer Reservoir Installation. Tighten the reservoir nuts and screw to 9 to 14 Nm (80 to 124 in. lbs.) torque. Fill reservoir.