DTC 18 - P0725
Name of Code:P-0725(18) - Engine Speed Input Circuit
When Monitored: Whenever the engine is running.
Set Condition: This code is set when the engine speed sensed by the Transmission Control Module (TCM) is less than 390 RPM or greater than 8000 RPM for more than 2.0 seconds.
Theory of Operation: The TCM uses a simulated Crank Sensor signal to calculate engine RPM. This signal is supplied by the PCM and uses a dedicated circuit called the EATX RPM Signal circuit. If the TCM interprets this signal to be out of range when the engine is running (as reported by the PCM over the bus) the code is set.
Transmission Effects: The MIL illuminates and the transmission system defaults to Relay Open limp-in mode.
Possible Causes:
- Open or short in EATX RPM Signal circuit
- TCM and/or PCM connector problems
- TCM
- PCM