Operation CHARM: Car repair manuals for everyone.

Compass Demagnetizing

A magnetic field can adversely affect the compass. Magnetic interference can magnetize the roof panel. Magnetizing can be caused by placing a permanent magnet in contact with the roof panel.

Examples:
- Magnetic base antenna
- Magnetic screwdriver
- Audio speakers
- Refrigerator magnets
- Pizza signs
- Bubble gum flasher lights

Removing magnetic interfering objects will usually restore normal compass
operation. If the compass display remains blank while the CAL label is illuminated, then the roof panel requires demagnetizing. To demagnetize, use Special Tool 6029 for demagnetizing the roof panel. The procedure will demagnetize the roof and the mounting screws for the EMTM. It is important that you follow the instructions below exactly. The mounting screws and the mounting bracket around the compass area are steel, and therefore aid in the demagnetizing of the roof panel.
1. Be sure the ignition switch is in the OFF position before you begin the procedure.
2. Plug the demagnetizing tool into a standard 110/115 volt AC outlet, keeping it at least 12 inches away from the compass area when plugging it in.
3. Slowly approach and contact the EMTM mounting screw with the plastic coated tip of the tool for at least two seconds.
4. With the tool still energized, slowly back it away from the screw until the tip is at least 12 inches from the screw head.
5. Repeat the first step with all the EMTM mounting screws.
6 After you have pulled away at least 12 inches from the mounting screw, remove the demagnetizing tool from inside the vehicle and disconnect it from the electrical outlet.
7 Place an 8-1/2 x 11 inch piece of paper length wise on the roof of the vehicle directly above the compass. The purpose of the paper is to protect the roof panel from scratches and to define the area to be demagnetized.
8. Plug in the tool, keeping it at least two feet away from the compass unit.
9. Slowly approach the center of the roof panel at the windshield with the tool.
10. Contact the roof panel with the tip of the tool. Using slow sweeping motions of 1/2 inch between sweeps, move the tool front to back approximately four inches either side of the center line and at least 11 inches back from the windshield.
11. With the demagnetizing tool still energized, slowly back away from the roof panel until the tip is at least two feet from the roof before unplugging the tool.
12. Recalibrate the compass (refer to the compass calibration procedure).