Operation CHARM: Car repair manuals for everyone.

Air Injection Vacuum Control Solenoid Valve: Testing and Inspection


Electro-Valve Control Switch Test (504 only)

1. Turn ignition on.

2. Using test light, check for voltage at switch terminal 82A. If test light comes on, proceed to step 3. If not, check fuse F5 on sedans or F3 on wagons and check circuit wiring for open.

3. Connect test light to terminal 82B and manually close contacts. If light does not indicate voltage, replace switch.

Electro-valve Test, 504 Models

NOTE:
This test should not be performed until after operation of electro-valve control switch has been checked.

Procedure

1. Turn ignition switch on.

2. Close electro-valve switch by rotating choke cam.

3. Check operation of valves by disconnecting electrical terminals. If clicking noise is heard, valve is operating correctly. If no noise is heard, replace defective electro-valve.


Electro-valve Test, 504 Models

NOTE:
This test should not he performed Until oil thermoswitch has been checked for proper operation.

Procedure

1. Turn ignition switch on.

2. Check each electro-valve separately by disconnecting one of the terminals. If clicking noise can be heard, valve is operating correctly. If no noise is heard, proceed to step 3.

3. Using test light, check for voltage at electro-valve connectors 32A and 32B. If test light comes on, replace electro-valve. If not, check fuse F2 and circuit for an open.