Operation CHARM: Car repair manuals for everyone.

Heated Oxygen Sensor (HO2S) 2 Replacement

TOOLS REQUIRED
J 39194-B Heated Oxygen Sensor Wrench

REMOVAL PROCEDURE

NOTE:
- Remove oxygen sensors with the engine temperature above 48°C (120°F). Otherwise the oxygen sensors may be difficult to remove.
- Take care when handling oxygen sensors. The electrical connector and louvered end must be kept free of contaminants. Do not use cleaning solvents on the sensor. Do not drop or mishandle the sensor.

IMPORTANT: A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound GM P/N 12377953 or equivalent.




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the heated oxygen sensor (HO2S) electrical connector.
3. Remove the HO2S from the exhaust pipe using the J 39194-B (1).

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.

IMPORTANT: Ensure that the correct replacement HO2S is used. The engine HO2S 1 and the post-converter HO2S 2 are both 6.6-watt Denso sensors. Due to differences in pigtail length, the sensors use different connectors and are not interchangeable.




1. Install the HO2S (1) to the rear exhaust pipe.

Tighten
Use the J 39194-B to tighten the HO2S to 41 N.m (30 lb ft).

2. Connect the HO2S electrical connector.
3. Lower the vehicle.