Operation CHARM: Car repair manuals for everyone.

Parking Lock Cable: Service and Repair

REMOVAL PROCEDURE





1. Set the park brake and block the wheels.
2. Remove the front floor console trim plate.
3. Disconnect and remove the park lock cable from the shift control and the bracket.





4. Remove the park lock cable from beneath the heater duct.
5. Remove the park lock cable from behind the accelerator pedal linkage and accelerator pedal bracket.
6. Disconnect the park lock cable from the pedal bracket.
7. Remove the steering column opening filler.
8. Remove the knee bolster in order to gain access to the ignition switch end of the park lock cable.
9. Turn the ignition to ACC.





10. Depress the park lock cable lock tab in order to release the park lock cable from the ignition switch.
11. Remove the park lock cable.

INSTALLATION PROCEDURE





1. Turn the ignition to ACC.
2. Install and connect the park lock cable to the ignition switch.





3. Connect the park lock cable to the pedal bracket.

IMPORTANT: Do not bend the cable less than a 102.00 mm (4 inch) radius during installation, the cable is not to be kinked or damaged.

4. Install and route the park lock cable behind the accelerator pedal linkage and accelerator pedal bracket.
5. Install and route the park lock cable beneath the heater duct.





6. Install and connect the park lock cable to the shift control and the bracket.
7. Verify the function of the park lock system.
8. Install the steering column opening filler and knee bolster bracket.
9. Remove the steering column opening filler.
10. Install the front floor console trim plate.
11. Release the park brake and remove the wheel blocks.