With Dual Zone A/C
Removal Procedure1. Remove the HVAC module. Service and Repair
2. Remove all of the outer HVAC module seals.
3. Remove the air inlet housing.
4. Unclip the heater/defrost valve vacuum actuator from the HVAC module.
Remove the heater/defrost valve vacuum actuator.
5. Remove the HVAC module case upper screws.
6. Separate the HVAC module case.
7. Remove the HVAC module seal that is between the upper and lower cases.
8. Remove the evaporator core.
9. Remove and discard the evaporator core lower seals.
10. Remove and discard the evaporator core upper seal.
11. Remove and discard the evaporator core side seal.
12. Remove and discard the water core filter.
Installation Procedure
1. Install the water core filter.
2. Install the new evaporator core seal to the evaporator core.
3. Install a new side seal to the evaporator core.
4. Install two new lower seals to the evaporator core.
5. Install the HVAC module seal (2) to the lower module case (1).
6. Install the evaporator core into the HVAC module lower case.
7. Align the guide (1) and attach the upper and lower HVAC module case.
Install the HVAC module upper screws.
Tighten
Tighten the HVAC module screws to 1.5 N.m (13 lb in).
8. Install the heater/defrost valve vacuum actuator to the HVAC module.
9. Install the air inlet housing.
Tighten
Tighten the air inlet housing screws to 1.5 N.m (13 lb in).
10. Install the HVAC module.