Operation CHARM: Car repair manuals for everyone.

Power Steering Line/Hose: Service and Repair












REMOVE OR DISCONNECT
1. Inlet hose, remove nut securing clamp to alternator bracket and disconnect power steering pressure sensor switch connector.
2. Outlet hose, remove two nuts securing clamps to alternator mounting.
3. Raise vehicle.
4. Front Splash shield.
5. Wheel Splash shield.
6. Bolts and retainers.
7. Alternator Frame Brace bolts.
8. Alternator Frame Brace.
9. Connections at gear and pump.
10. Hose.

INSTALL OR CONNECT
1. Hose into place.
2. Connections at gear and pump.
3. Alternator Frame Brace.
4. Alternator Frame Brace bolts.
5. Retainers and bolts.
Tighten:
^ Retainer bolts to 6 Nm (53 inch lbs.).
^ Power steering gear inlet hose to pump, to 27 Nm (20 inch lbs.).
^ Power steering gear inlet hose to steering gear, to 27 Nm (20 inch lbs.).
6. Wheel Splash shield.
7. Front Splash shield.
8. Lower vehicle.
9. Inlet hose, install clamp at alternator bracket and connect power steering pressure sensor switch connector.
10. Outlet hose, install two nuts securing clamps to alternator mounting.
11. Fill and bleed system.
^ Inspect for leaks.