Engine Block Heater: Service and Repair
Engine Coolant Heater:
REMOVE OR DISCONNECT
1. Master cylinder from vacuum booster and position out of way.
2. Wiring harness and transmission vent tube from engine lift bracket and position out of way.
3. Shift cable from transaxle.
4. Neutral safety switch from transaxle and position out of way.
5. Engine coolant heater connector
6. Engine coolant heater by pulling back tab and sliding out.
INSTALL OR CONNECT
1. Engine coolant heater to block.
2. Heater cord to engine coolant heater.
3. Neutral safety switch to transaxle.
4. Shift cable to transaxle.
5. Wiring harness and transmission vent tube to engine lift bracket.
6. Master cylinder to vacuum booster.
Cord Routing:
NOTICE: The heater cord must not touch the engine, hot pipes, manifold, or any moving parts. Route the cord as shown in figure above to the left front of the engine compartment securing with tie straps as necessary.