Operation CHARM: Car repair manuals for everyone.

Sedan Rear Doors

WINDOW REGULATOR - SEDAN REAR DOOR

^ Coupe and sedan front doors use a single lift arm regulator. The sedan rear doors use a tape drive regulator. The following provides the procedures required for removal and replacement of both power and manual window regulators.

Door Window Removal - Sedan Rear Doors:






REMOVE OR DISCONNECT

IMPORTANT
^ Tape window to the full-up position.

1. Door trim panel.
2. Water deflector.
3. Nuts securing regulator sash to glass assembly.
4. Rivets using 6.3 mm (1/4 inch) drill bit.
5. Electrical connector from motor (power window systems).
6. Regulator through access hole in door inner panel.

INSTALL OR CONNECT
1. Regulator through access hole.
2. Electrical connector to motor (power window system).
3. Rivets using 1/4 inch x 1/2 inch peel type rivets.
4. Nuts

TIGHTEN
Nuts to 9 N.m (80 lb in).

5. Water deflector.
6. Door trim panel.