Test D: Blower Speed Control Switch
1. Remove the connector from the Blower Resistor Assembly. Measure the voltage to ground at the following terminals of the connector.Test D Blower Speed Control Switch Test Part 1 Of 2:
^ If all voltages are normal, proceed to step 2.
^ If Battery voltage is not present at Terminal A, check BRN/WHT wire (64) for open between Blower Resistor Assembly and Blower Off Relay Terminal B.
^ If Battery voltage is present at Terminal A but not at Terminals C or D, check the BRN/WHT wire (64) for an open between the Blower Resistor Terminal A and the Blower Speed Control Switch Terminal E.
^ If the voltages at Terminals C or D are not correct, check the TAN (63) and LT BLU (72) wires for opens or shorts. If wires are good, repair or replace the Blower Speed Control Switch.
2. Measure the voltage to ground at terminal E of the High Speed Blower Relay.
Test D Blower Speed Control Switch Test Part 2 Of 2:
^ If voltages in steps 1 and 2 are good, Blower Speed Control Switch is good.
^ If voltages are incorrect at Terminal E, check the ORN wire (52) for an open or short. If ORN wire is good, repair or replace the Blower Speed Control Switch.