Test C: Heater-A/C Control Assembly Test
Test C Heater-A/C Control Assembly Test:
1. Remove connector C2 from the Heater-A/C Control Assembly. Measure the voltage to ground at the terminals of C2 listed in the table.
^ If all voltages are correct but indicators don't light, replace the Heater-A/C Control Assembly. If indicators are good, proceed to step 2.
^ If voltage is not correct at terminal D, check Fuse 14 and ORN wire (40) for an open or short to ground.
^ If voltage is not correct at terminal .1, check Fuse 7 and the BRN wire (50) for an open or short to ground.
^ If voltage is not correct at terminal 7, check the BRN/WHT wire (954) for an open. If wire is good, complete Test B: Blower Off Relay Test.
2. Turn Ignition Switch to OFF for several seconds, then turn it back to RUN. Check that A/C Control Assembly returns to same mode setting as before Ignition was turned off. Make test using several different modes.
^ If the A/C System does not return to the same mode and all voltages are correct, replace the Heater A/C Control Assembly.
3. Move the Fan Switch through all positions.
^ Check that proper window is lighted in each position.
^ If all windows do not light, replace or repair the Fan Switch.
^ If all voltages are correct but indicators don't light, replace the Heater-A/C Control Assembly.