Operation CHARM: Car repair manuals for everyone.

Passenger Side


MIRROR SENSOR:_:PASSENGER SIDE





Description
- The mirror sensor RH is installed to the door mirror RH.
- The resistance of 2 sensors (horizontal and vertical) is changed when the door mirror RH is operated.
- Automatic drive positioner control unit calculates the door mirror position according to the change of the voltage of 2 sensor input terminals.




Component Function Check
1. CHECK FUNCTION
1. Select "MIR/SEN RH U-D", "MIR/SEN RH R-L" in "Data monitor" with CONSULT-III.
2. Check the mirror sensor RH signal under the following conditions.





Is the indication normal?
YES - Inspection End.
NO - Perform diagnosis procedure. SEE Diagnosis Procedure.




Diagnosis Procedure
Regarding Wiring Diagram information, Electrical Diagrams.
1. CHECK DOOR MIRROR RH SENSOR SIGNAL





1. Turn ignition switch to ACC.
2. Check voltage between door mirror RH harness connector and ground.





Is the inspection result normal?
YES - GO TO 5
NO - GO TO 2
2. CHECK DOOR MIRROR RH SENSOR CIRCUIT 1





1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror RH.
3. Check continuity between automatic drive positioner control unit harness connector and door mirror RH harness connector.





4. Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES - GO TO 3
NO - Repair or replace harness.
3. CHECK DOOR MIRROR RH SENSOR CIRCUIT 2





1. Check continuity between automatic drive positioner control unit harness connector and door mirror RH harness connector.





2. Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES - GO TO 4
NO - Repair or replace harness.
4. CHECK TILT MOTOR ADJUSTING OPERATION
1. Connect automatic drive positioner control unit and door mirror RH.
2. Turn ignition switch ON.
3. Check tilt motor adjusting operation with memory function.
Is the operation normal?
YES - Replace door mirror actuator. (Built in door mirror RH). Removal And Installation.
NO - Replace automatic drive positioner control unit. Service and Repair.
5. CHECK INTERMITTENT INCIDENT
Intermittent Incident.
Is the inspection result normal?
YES - Replace automatic drive positioner control unit. Service and Repair.
NO - Repair or replace the malfunctioning part.