Main Line Between STRG And YAW Circuit
MAIN LINE BETWEEN STRG AND YAW CIRCUIT
Diagnosis Procedure
1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect the following harness connectors.
- ECM
- Steering angle sensor
- Yaw rate/side/decel G sensor
4. Check the continuity between the harness connectors.
Is the inspection result normal?
YES - GO TO 2.
NO - Repair the main line between the steering angle sensor and yaw rate/side/decel G sensor.
2.ERASE ALL DTC
1. Connect all the connectors.
2. Erase the DTCs of unit connected to HEV SYSTEM CAN and CAN.
3. Turn the ignition switch OFF.
4. Turn the ignition switch ON.
5. Perform All DTC Reading with CONSULT-III.
NOTE:
For DTCs related to HEV SYSTEM CAN, Related Tests, Information and Procedures.
Is the DTC related to HEV SYSTEM CAN displayed?
YES - Reconfirm the procedure for detecting root cause.
NO - Error was detected in the main line between the steering angle sensor and yaw rate/side/decel G sensor.