Operation CHARM: Car repair manuals for everyone.

Main Line Between EPS And DLC Circuit


MAIN LINE BETWEEN EPS AND DLC CIRCUIT





Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
- Harness connector E30
- Harness connector M1
Is the inspection result normal?
YES - GO TO 2.
NO - Repair the terminal and connector.
2.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
1. Disconnect the following harness connectors.
- Harness connectors E301 and E67
- Harness connectors E30 and M1
2. Check the continuity between the harness connectors.





Is the inspection result normal?
YES - GO TO 3.
NO - Repair the main line between the harness connector E67 and E30.
3.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
Check the continuity between the harness connector and the data link connector.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair the main line between the harness connector M1 and the data link connector.
4.ERASE ALL DTC
1. Connect all the connectors.
2. Erase the DTCs of unit connected to HEV SYSTEM CAN and CAN.
3. Turn the ignition switch OFF.
4. Turn the ignition switch ON.
5. Perform All DTC Reading with CONSULT-III.

NOTE:
For DTCs related to HEV SYSTEM CAN, Related Tests, Information and Procedures.
Is the DTC related to HEV SYSTEM CAN displayed?
YES - Reconfirm the procedure for detecting root cause.
NO - Error was detected in the main line between the EPS control unit and the data link connector.