CAN
MAIN LINE BETWEEN HVAC AND DLC CIRCUIT
Diagnosis Procedure
INSPECTION PROCEDURE
1. CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect the following harness connectors.
- ECM
- A/C auto amp.
4. Check the continuity between the A/C auto amp. harness connector and the data link connector.
Is the inspection result normal?
YES (Present error) - Check CAN system type decision again.
YES (Past error) - Error was detected in the main line between the A/C auto amp. and the data link connector.
NO - Repair the main line between the A/C auto amp. and the data link connector.