Operation CHARM: Car repair manuals for everyone.

CVT Controls - Delayed Engagement Into Drive or Reverse

Classification: AT10-007

Reference: NTB10-147

Date: December 20, 2010

2007 ALTIMA;
DELAYED ENGAGEMENT WHEN SHIFTING IN DRIVE OR REVERSE

APPLIED VEHICLE: 2007 Altima Sedan (L32) with QR25 engine and CVT only

IF YOU CONFIRM:

The CVT has a delayed engagement after shifting in Drive and / or Reverse

AND

There are no DTCs stored in the ECM and / or TCM.

NOTE:
Engagement in both Drive and Reverse within three (3) seconds after shifting is considered normal.

ACTION:

1. Refer to Step 2 in the Service Procedure to confirm this bulletin applies to the vehicle you are working on.

2. If this bulletin applies, reprogram the TCM.





CLAIMS INFORMATION

IMPORTANT:
The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.

SERVICE PROCEDURE

1. Connect CONSULT III (C-III) to the vehicle to begin the reprogramming procedure.

^ If you are not familiar with the reprogramming procedure, refer to "CONSULT- III (C-III) TCM Reprogramming" general procedure.





CAUTION





2. When you get to the TCM Reprogramming screen shown in Figure 1, confirm this bulletin applies as follows:

A. On your C-III screen, look at the Part Number column (see Figure 1 example).

^ If this column is blank (no part number listed), this bulletin does not apply. If a part number (P/N) is listed, write it on the Repair Order and then go to Step B.





B. Compare the P/N you wrote down to the P/Ns in the Current TCM P/N column in Table A above.

^ If there is a match, this bulletin applies. Continue with the reprogramming procedure.

NOTE:
If there are two lines (two reprogramming options) on your C-III screen, use the one that does not have the message "Caution! Use ONLY with NTBXX-XXX".

^ If there is not a match, this bulletin does not apply.





3. If this bulletin applies and you have performed TCM reprogramming; when reprogramming is complete, the screen in Figure 2 appears.

4. Verify the CVT engages in both Drive and Reverse within three (3) seconds after shifting.





Disclaimer