Operation CHARM: Car repair manuals for everyone.

Engine Controls - Engine Rattling Noises On Cold Start

Classification: EC07-010A

Reference: NTB08-014A

Date: May 6, 2009

2007 ALTIMA; QR25 ENGINE RATTLE NOISE WHEN COLD

This bulletin has been amended. The Claims Information and Service Procedure have been updated. No other changes have been made. Please discard all previous versions of this bulletin.

APPLIED VEHICLES: 2007 Altima Sedan (L32)
with QR25 engine and CVT (excludes Hybrid and models with M/T)

IF YOU CONFIRM:

Rattling or knocking noise from the engine when all of the following conditions are met:

1. The rattle noise is not coming from the catalytic converter heat shield (refer to campaign bulletin NTB08-001), and

2. The engine oil level is in the operating range, and

3. Engine is OFF for 2 hours or more (cold soak of 2 hours or more), and

4. Cold start with engine coolant temperature below 122°F (50°C), and

5. The noise lasts for 1 minute or more during engine warm up, and

6. At idle or low speeds - engine rpm below 2200.

ACTIONS:

Confirm this bulletin applies:

^ Check and compare your Current ECM Part Number to Table A.

If that part number does not match one in Table A, this bulletin does not apply. Go back to ASIST for further diagnostic and repair information.

If this bulletin applies, reprogram the ECM.

IMPORTANT:
The purpose of "ACTIONS" (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire Service Procedure as it contains information that is essential to successfully completing this repair.





CLAIMS INFORMATION

SERVICE PROCEDURE

1. Connect C-III to the vehicle to begin the ECM reprogramming procedure.





CAUTION





2. When you get to the ECM Reprogramming screen shown in Figure 1, confirm this bulletin applies as follows:

A. On your C-III screen, look at the Part Number column (see Figure 1):

^ If this column is blank (no part number listed), this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.

^ If a Part Number is listed, write it on the Repair Order.





B. Go to Table A shown above.

C. Compare the Part Number you wrote down to the numbers in the Current ECM Part Number column in Table A.

^ If there is a match, this bulletin applies. Continue with the reprogramming procedure.

^ If there is not a match, this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.





3. If this bulletin applies and you have performed ECM reprogramming, the screen in Figure 2 appears when reprogramming is complete.

4. Make sure to erase DTCs from all systems.

NOTE:
During the reprogramming, DTCs will set in several systems. DTCs must be erased from all systems.

5. Verify the engine rattle noise is reduced.