Operation CHARM: Car repair manuals for everyone.

Rod Bearing Cap

Rod Bearing Cap





Assemble so that the front mark on the piston crown and the oil holes and the cylinder No. on the connecting rod are positioned as shown.





Install the snap ring into the front of the piston pin-groove.
After installing, check that the connecting rod pivots smoothly on the pin.








Install the connecting rod bearings to the connecting rod and the connecting rod cap.
When installing the connecting rod bearings, apply engine oil to the bearing surface (crankshaft side). Do not apply oil to the back surface (connecting rod and cap side), but thoroughly clean it.
When installing, align the connecting rod bearing protrusion with the notch of the connecting rod to install.
Check that the oil holes on the connecting rod and on the corresponding bearing are aligned.





Install the piston and connecting rod assembly into the corresponding cylinder.
Position the crankshaft pin corresponding to the connecting rod to be installed onto the bottom dead center.
Apply engine oil sufficiently to the cylinder bore, piston, and crankshaft pin.
Match the cylinder position with the cylinder No. on the connecting rod to install.
Install the piston with the front mark on the piston crown facing the front of the engine, using a suitable tool.

CAUTION: Be careful not to damage the crankshaft pin and cylinder wall, resulting from an interference of the connecting rod big end.





Install the connecting rod cap.
Match the stamped cylinder number marks on the connecting rod with those on the cylinder cap for installation.
Install the piston connecting rod assembly and cap so that the front mark on the cap and piston are facing the front of the engine.
Lubricate the threads and seat surfaces with new engine oil.





Check the connecting rod cap bolts before reusing, then install in their original position in the connecting rod. The bolts should screw in smoothly by hand.
Measure the outer diameter of the connecting rod cap bolt as shown.
Outer diameter d of the connecting rod bolt
Standard 7.90 - 8.00 mm (0.3110 - 0.3150 inch)
Limit 7.75 mm (0.3051 inch)





Tighten the connecting rod nuts in two stages:
Stage 1 19 - 21 Nm (1.9 - 2.1 kg-m, 14 - 15 ft. lbs.)
Stage 2 90° - 95° degrees clockwise

CAUTION: Always use either an angle wrench or protractor. Avoid tightening based on visual check alone.

Tool number: KV10112100 (BT-8653-A)
Apply engine oil to the threads and seats of the connecting rod bolts and nuts.
After tightening the nuts, make sure that the crankshaft rotates smoothly.