Lock-Up Is Not Released
Lock-up Is Not ReleasedSYMPTOM: The lock-up condition cannot be cancelled even after releasing the accelerator pedal.
1. CHECK A/T FLUID LEVEL
Check the A/T fluid level.
OK or NG
OK >> GO TO 2.
NG >> Refill ATF.
2. CHECK STOP LAMP SWITCH CIRCUIT
Check the stop lamp switch circuit.
OK or NG
OK >> GO TO 3.
NG >> Repair or replace damaged parts.
3. CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis.
Is any malfunction detected by self-diagnostic?
YES >> Check the malfunctioning system.
NO >> GO TO 4.
4. DETECT MALFUNCTIONING ITEM
1. Control valve assembly.
2. Disassemble "A/T".
3. Check the following items:
- Torque converter.
OK or NG
OK >> GO TO 5.
NG >> Repair or replace damaged parts.
5. CHECK TCM
1. Check TCM input/output signal.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> GO TO 6.
NG >> Repair or replace damaged parts.
6. CHECK SYMPTOM
Check again.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.