Operation CHARM: Car repair manuals for everyone.

Rod Bearing Cap

Rod Bearing Cap





Install the connecting rod cap.
Match the stamped cylinder number marks on the connecting rod with those on the cylinder cap for installation.
Install the piston connecting rod assembly and cap so that the front mark on the cap and piston are facing the front of the engine.
Lubricate the threads and seat surfaces with new engine oil.





Check the connecting rod cap bolts before reusing, then install in their original position in the connecting rod. The bolts should screw in smoothly by hand.
Measure the outer diameter of the connecting rod cap bolt as shown.
Outer diameter "d" of the connecting rod bolt
Standard 7.90 - 8.00 mm (0.3110 - 0.3150 inch)
Limit 7.75 mm (0.3051 inch)





Tighten the connecting rod nuts in two stages:
Stage 1 19 - 21 Nm (1.9 - 2.1 kg-m, 14 - 15 ft. lbs.)
Stage 2 90° - 95° clockwise

CAUTION: Always use either an angle wrench or protractor. Avoid tightening based on visual check alone.

Tool number: KV10112100 (BT-8653-A)
Apply engine oil to the threads and seats of the connecting rod bolts and nuts.
After tightening the nuts, make sure that the crankshaft rotates smoothly.