CONSULT-II Operation

CONSULT-II Functions (IPDM E/R)




CONSULT-II can display each diagnostic item using the following test modes: work support, self-diagnosis, data monitor, and active test through data reception and command transmission via the IPDM E/R CAN communication lines.

CONSULT-II OPERATION

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.




1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch ON.




2. Touch "START (NISSAN BASED VHCL)".




3. Touch "IPDM E/R" on "SELECT SYSTEM" screen.





4. Select the desired part to be diagnosed on the "SELECT DIAG MODE" screen.