A/T Does Not Perform Lock-Up
A/T Does Not Perform Lock-upSYMPTOM: A/T does not perform lock-up at the specified speed.
DIAGNOSTIC PROCEDURE
1. CHECK A/T FLUID LEVEL
Check the A/T fluid level again. Refer to "A/T FLUID CHECK".
OK or NG
OK >> GO TO 2.
NG >> Refill ATF.
2. CHECK STOP LAMP SWITCH CIRCUIT
Check the stop lamp switch circuit.
OK or NG
OK >> GO TO 3.
NG >> Repair or replace damaged parts.
3. CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis. Is any malfunction detected by self-diagnostic?
YES >> Check the malfunctioning system.
NO >> GO TO 4.
4. CHECK TCM
1. Check TCM input/output signal.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> GO TO 5.
NG >> Repair or replace damaged parts.
5. SYMPTOM CHECK
Check again.
OK or NG
OK >> INSPECTION END
NG >> Replace the transaxle assembly.