Operation CHARM: Car repair manuals for everyone.

Component Tests

BRAKE SIGNAL CIRCUIT

Diagnostic Procedure
1. CHECK CAN COMMUNICATION LINE
Execute the self-diagnosis. Is a malfunction in the CAN communication indicated in the results?

Yes or No
Yes >> Check the CAN communication line. Refer to "DTC U1000 CAN COMMUNICATION LINE" U1000
No >> GO TO 2.

2. CHECK STOP LAMP SWITCH CIRCUIT

With CONSULT-II
1. Turn ignition switch "ON". (Do not start engine.)





2. Select "TCM INPUT SIGNALS" in "DATA MONITOR" mode for "A/T" with CONSULT-II.
3. Read out ON/OFF switching action of the "BRAKE SW".

OK or NG
OK >> INSPECTION END
NG >> GO TO 3.

3. CHECK STOP LAMP SWITCH





Check continuity between stop lamp switch harness connector E111 terminals 1 (R/Y) and 2 (P/L).
Check stop lamp switch after adjusting brake pedal-refer to "BRAKE PEDAL".

OK or NG
OK >> INSPECTION END
NG >> Check the following items. If NG, repair or replace damaged parts.
^ Harness for short or open between battery and stop lamp switch.
^ Harness for short or open between stop lamp switch and unified meter and A/C amp.