BARO / MAP Sensor Switching Valve: Testing and Inspection
COMPONENT INSPECTIONWITH CONSULT
1. Start engine and warm it up sufficiently.
2. Perform "MAP/BARO SW/V" in "ACTIVE TEST" mode with CONSULT.
3. Check the following.
- When "MAP" is selected, "ABSOL PRES/SE" indicates approximately 1.3V.
- When "BARO" is selected, "ABSOL PRES/SE" indicates approximately 4.3V.
4. If NG, replace solenoid valve.
OR
WITH NO TOOLS
1. Remove MAP/BARO switch solenoid valve.
2. Check air passage continuity.
3. If NG, replace solenoid valve.