Memory Positioning Module: Service and Repair

AUTOMATIC DRIVE POSITIONER CONTROL UNIT

Removal and Installation


REMOVAL


CAUTION:
When removing and installing, use shop cloths to protect parts from damage.
1.Remove the battery negative terminal. Removal and Replacement.
2.Remove the instrument lower panel LH using a suitable tool. Removal And Installation.





3.Remove the automatic drive positioner control unit screw (A).
4.Separate automatic drive positioner control unit (1) from bracket and disconnect electrical connectors.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
- Clamp the harness in position.
NOTE:
After installing the automatic drive positioner control unit, perform additional service when disconnecting battery negative terminal. Special Repair Requirement.