Operation CHARM: Car repair manuals for everyone.

System Specifications

Exploded View EM-60 (Part 1):




Exploded View EM-60 (Part 2):





Timing Chain Tensioner

Crankshaft Pulley
Tighten crankshaft pulley bolt.
Torque 44.1 Nm (4.5 kg-m, 33 ft-lb)





Place a paint mark (A) on crankshaft pulley (1) aligning with the angle mark (B) on crankshaft pulley bolt (2). Tighten the bolt 90 degrees (Angle tightening).
Rotate crankshaft pulley in normal direction (clockwise when viewed from engine front) to confirm it turns smoothly.

Timing Cover
Rear timing chain case





Tighten mounting bolts in numerical order as shown in the figure.
There are two types of mounting bolt. Refer to the following for locating bolts.
Bolt length: Bolt position
20 mm (0.79 in): 1, 2, 3, 6, 7, 8, 9, 10
16 mm (0.63 in): Except the above
Torque 12.7 Nm (1.3 kg-m, 9 ft-lb)
After all bolts tightening, retighten them to the specified in numerical order as shown in the figure.

Front timing chain case





Tighten mounting bolts to the specified torque in numerical order as shown in the figure.
There are two types of mounting bolt. Refer to the following for locating bolts.
M8 bolts: 1, 2 28.4 Nm (2.9 kg-m, 21 ft-lb)
M6 bolts: Except the above 12.7 Nm (1.3 kg-m, 9 ft-lb)
After all bolts tightening, retighten them to the specified torque in numerical order as shown in the figure.