Operation CHARM: Car repair manuals for everyone.

Crankshaft Main Bearing






Crankshaft Main Bearing Cap Bolts

Inspection





Check that the shank length of each bolt meets the limit. If it exceeds the limit, replace the bolt

Limit 71.1 mm (2.79 inches)

Tightening Sequence





First step 25 ± 2 Nm (18 ± 1 ft-lb)
Second step Tighten 90°

Crankshaft End Play
Standard value 0.05 - 0.25 mm (0.002 - 0.009 inch)
Limit 0.40 mm (0.015 inch)

Crankshaft Bearing Selection

When bearing replacement is required, select and install the correct bearing by the following procedure





Measure the crankshaft journal diameter and confirm its classification from the following table. In the case of a crankshaft supplied as a service part, identification marks of its journals are stamped at the positions shown in the illustration





The cylinder block bearing bore diameter identification marks are stamped at the position shown in the illustration from left to right, beginning at No. 1









For example, if the crankshaft journal outside diameter identification mark is "0" and cylinder block bearing bore identification mark is "1," select a bearing whose identification mark is "2" for number 1, 2, 4 and 5, and a bearing whose identification mark is "1" for number 3
If there is no identification mark on the crankshaft, measure the journal outside diameter and select a bearing appropriate for the measured value





Install the bearings having an oil groove to the cylinder block
Install the bearings having no oil groove to the bearing cap