Oil Filter: Service and Repair
Change
This vehicle is equipped with a full-flow, throw-away oil filter. The same type of replacement filter is recommended as a replacement filter for this vehicle. It is possible, particularly in cold weather, that this vehicle may develop high oil pressure for a short duration. You should be sure that any replacement filter used on this vehicle is a high-quality filter and is capable of withstanding a pressure of 256 psi (manufacturer's specifications) to avoid filter and engine damage.
Any replacement oil filter should be installed in accordance with the oil filter manufacturer's installation instructions.
1. Remove the engine oil filler cap.
2. Remove the engine oil drain plug, and drain out the engine oil.
3. Remove the engine oil filter by using the oil filter wrench.
4. Clean the oil filter mounting surface of the oil filter bracket.
5. Coat engine oil to the O-ring of new oil filter.
6. Screw on the oil filter by hand until it touches the surface of the flange and then tighten a further 3/4 turn.
7. Add new engine oil through the oil filler.
8. Start and run engine and check for engine oil leaks.
9. After stopping the engine, check oil level and replenish as necessary.
Engine Oil Total Quantity:
[including oil filter] 4.3 cu.dm (4.5 qts.)