Operation CHARM: Car repair manuals for everyone.

Cruise Control Servo Cable: Adjustments

Fig. 55 Wiper Operation Stop Check:





1. Turn all accessories Off, warm up engine until specified idling speed is reached, then turn engine off.
2. Remove air cleaner, then depress accelerator pedal completely, ensuring throttle valve operates smoothly from full close to full open.
3. On models equipped with automatic transmission, turn ignition switch to On position for 15 seconds, ensuring throttle lever returns.
4. On all models, check accelerator inner cable for too much or too little slack.
5. Loosen adjusting nut so that the throttle lever is free.
6. Turn the accelerator adjusting nut to the point where the throttle lever starts to move, then back off 1/2 turn and tighten locknut, Fig. 55.
7. Ensure idle position switch contacts stopper after idle speed control adjustment.
8. Adjust speed control cable to the point just before the accelerator pedal begins to move. Deflection of the speed control cable should measure 0--.12 inch.

Fig. 56 Rear Wiper & Washer Connector Identification:





9. Install a clip to secure the speed control cable, Fig. 56.