Operation CHARM: Car repair manuals for everyone.

EGR Control Solenoid Valve


1. Disconnect and mark the vacuum hoses (blue stripe, red stripe) connected to the solenoid valve.
2. Disconnect the harness connector.


Fig. 188a Testing the EGR valve:





3. Connect a hand vacuum pump to the nipple the red striped hose was removed from, Fig. 188a.


Fig. 189 Testing the EGR valve:





4. Apply a vacuum to the solenoid valve and verify that when battery voltage is applied vacuum leaks and when power is removed vacuum holds, Fig. 189.

Fig. 190 Testing the EGR valve:





5. Measure the solenoid coil resistance with a volt ohm meter, Fig. 190. Verify that coil resistance is between 36 and 44 ohms a 20 degrees C (68 degrees F).