Repair Procedure 2

PROCEDURE 2: RE-CALIBRATION OF SECONDARY AIR INJECTION SYSTEM BY INSTALLING AN INTERMEDIATE WIRING HARNESS

Figure 11:

1. From Parts Kit MD162375 obtain the intermediate wiring harness and harness band shown in Figure 11.

Figure 12:

Figure 14:

2. Install the harness as shown in Figures 12, 13, and 14.

Figure 13:

NOTE: Figure 13 shows the location of the intermediate wiring harness in the electrical system.
NOTE: Figure 14 shows how to bind the intermediate harness to existing wiring.

Figure 15:

3. From the parts kit obtain the "EMISSION RECALL COMPLETED" label. Using an indelible pen, write your dealership's 5 digit dealer code number in the space entitied "REPAIR FACILITY CODE NO.". Affix the label to a clean surface inside the car's engine compartment next to the emission control label.