Operation CHARM: Car repair manuals for everyone.

Parking Assist Control Module: Service and Repair




Parking Aid Module (PAM) - Mountaineer









Removal and Installation

1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.

Upload the PAM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programmable Module Installation (PMI)

2. Remove the RH quarter trim panel.

3. If replacing the parking aid speaker only, proceed as follows:
- Disconnect the parking aid speaker electrical connector.

- Remove the parking aid speaker push pins.

- Remove the parking aid speaker.

4. If replacing the Parking Aid Module (PAM), proceed as follows:
- Disconnect the PAM and parking aid speaker electrical connectors.

- Remove the screw.

- Remove the PAM.

5. To install, reverse the removal procedure.
- Download the configuration information to the PAM. For additional information, refer to PMI in Information Bus. Programmable Module Installation (PMI)