Case: Service and Repair
NOTE: The oil seals do not need to be removed unless you are replacing them.Part 1 Of 2:
Part 2 Of 2:
DISASSEMBLY / ASSEMBLY
1. Disassemble in the order shown in the illustration, referring to Disassembly Note.
2. Select adjustment shim(s). Adjustments
3. Assemble in the reverse order of disassembly, referring to Assemble Note.
Disassembly Note
Blind Plug (8)
Remove the roll pin with pliers.
Reverse Lever Shaft (9)
Protect the reverse lever shaft with a rag and remove the shaft with pliers.
Oil Seal (Change Rod) (18)
Remove the oil seal with a screwdriver.
Funnel And Bearing Race (Secondary Shaft) (22, 27)
NOTE: Remove the bearing race with a screwdriver if necessary.
1. Insert a screwdriver between the clutch housing and bearing race.
2. Pry the bearing race free.
Remove the bearing race by lifting out the funnel and race together.
Oil Seal (Primary Shaft) (20)
CAUTION: Do not damage the clutch housing.
Remove the oil seal with a screwdriver.
Oil Seal (Differential) (26)
Remove the oil seal with a screwdriver.
Bearing Race And Adjustment Shim (Differential) (30, 31)
1. Install the Special Service Tool (SST) to the bearing race.
2. Remove the bearing race and adjustment shim.
Inspection
Vehicle Speedometer Sensor (Speedometer Driven Gear) (1)
1. Inspect the teeth for damage and wear.
2. Inspect the O-ring for damage and wear.
Reverse Lever (11)
1. Inspect gear teeth for damage, wear, and cracks.
2. Measure the clearance between the reverse idler gear bushing and the reverse lever. Standard clearance should be within 0.10 - 0.32 mm (0.004 - 0.013 inch) and a maximum of 0.37 mm (0.015 inch).
Assembly Note
Oil Seal (Differential) (26)
1. Apply transaxle oil to the outer circumference of the oil seal.
2. Install the new oil seal by using the SST.
Adjustment Shim And Bearing Race (Secondary Shaft Gear) (28, 27)
CAUTION: Use adjustment shim(s) selected during bearing preload adjustment.
1. Apply transaxle oil to the bearing race.
2. Install the adjustment shim(s) and the bearing race with a suitable pipe.
Adjustment Shim And Bearing Race (Differential) (31, 30)
CAUTION: Use adjustment shim(s) selected during bearing preload adjustment.
1. Apply transaxle oil to the bearing race.
2. Install the adjust shim(s) and the bearing race with a suitable pipe.
Adjustment Shim (Primary Shaft Gear) (29)
CAUTION: Use adjustment shim(s) selected during bearing preload adjustment.
Apply transaxle oil to the adjustment shim(s) and install it.
Oil Seal (Primary Shaft Gear) (20)
1. Apply transaxle oil to the outer circumference of the oil seal.
2. Install the new oil seal with a suitable pipe.
Oil Seal (Change Rod) (18)
CAUTION: Do not damage the oil seal.
1. Apply transaxle oil to the oil seal lip.
2. Install the new oil seal by using a suitable pipe with an outer diameter of 26.0 mm (1.02 inch).
Boot And Change Rod Assembly (17, 16)
Install the boot with the air bleeder hole facing downward as shown in the illustration.