Rear

PROCEDURE
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal indicated in the table.
3. After installation, depress the pedal a few times. Then rotate the wheel by hand, and verify that the brakes do not drag.





REMOVAL NOTES
Manual Adjustment Gear
Turn the manual adjustment gear counterclockwise by using an Allen wrench to pull the brake caliper piston inward. (Turn until it stops.)





Disc Plate
Mark the wheel hub bolt and disc plate before removal for reference during installation.

INSTALLATION NOTES





Disc Pad
1. Push the piston fully inward by using the Special Service Tool (SST).
2. Install the disc pad.
3. Bleed brakes. Service and Repair





Manual Adjustment Gear
1. Turn the manual adjustment gear clockwise until the brake pads just touch the disc plate.
2. Return the manual adjustment gear 1/3-turn.

Disc Plate
1. Remove any rust or grime on the contact face of the disc plate and wheel hub.
2. Install the disc plate and align the marks made before removal.