Reverse-Fourth Gear Carrier Assembly
DISASSEMBLY
1. Disassemble in the order shown in the illustration, referring to the following note:
Bearing
1. If necessary, use the Special Service Tools (SSTs) or equivalent to remove the drive sprocket bearing.
2. If necessary, use the SSTs or equivalent to remove the stator support bearing.
INSPECTION
Inspect the Reverse/fourth gear carrier assembly pinion gear end play. End play should be between 0.15 - 0.72 mm (0.006 - 0.028 inch).
ASSEMBLY
- Assemble in the reverse order of disassembly, referring to following steps:
1. If removed, install the drive sprocket bearing on the SST.
2. If removed, use the SSTs or equivalent to install the drive sprocket bearing.
3. If removed, install the stator support bearing on the SST.
4. If removed, use the SSTs or equivalent to install the stator support bearing.