Backing Plate: Service and Repair
1. Remove the components in the order shown in the figure.
^ Disconnect the brake pipe from the wheel cylinder with the Special Service Tool (SST).
2. Inspect all parts and repair or replace as necessary.
3. Install in the reverse order of removal.
^ Tighten to 50-68 Nm (37-50 ft. lbs.).
4. After installation, check the following.
a. Add fluid and bleed the air. Service and Repair
b. Check for fluid leakage.
c. Depress the pedal a few times, then verify that the brakes do not drag while rotating the wheel by hand.
d. Check the parking brake lever stroke.