Operation CHARM: Car repair manuals for everyone.

Attaching Engine To Stand






MOUNTING
1. Remove components in the order indicated in the table.






2. Install the Special Service Tool (SST), engine hanger using the holes shown in the image.





3. Install the SST (arms) to the holes as shown in the image, and hand tighten the SST (bolts).





4. Assemble the SST bolts and plate in the specified position.
5. Assemble the SST (nuts, hooks, and bolts).





6. Install the SST to the respective arms.





7. Adjust the SST (bolts) so that less than 20 mm (0.79 inch) of thread is exposed.
8. Make the SST (plate and arms) parallel by adjusting the SST (bolts and nuts).
9. Tighten the SST (bolts and nuts) to affix the SST firmly.





10. Mount the engine on the SST (engine stand).

DISMOUNTING
1. Dismount in the reverse order of mounting.
2. Install components in the reverse order of removal.