Piston: Testing and Inspection
1. Inspect the outer circumferences of all pistons for seizure or scoring. Replace the piston if necessary.2. Measure the outer diameter of each piston at a right angle (90°) to the piston 16.5 mm (0.65 inch) below the oil ring groove lower edge.
NOTE: Piston diameters are as follows:
^ Standard: 82.954-82.974 mm (3.2659-3.2666 inch).
^ Oversize:
- 0.25 mm (0.01 inch): 83.211-83.217 mm (3.2761-3.2762 inch).
- 0.50 mm (0.02 inch): 83.461-83.467 mm (3.2859-3.2860 inch).
3. Measure the piston-to-cylinder clearance. The clearance should measure 0.032-0.059 mm (0.0013-0.0023 inch) with a maximum measurement of 0.15 mm (0.006 inch).
4. If the clearance exceeds the maximum, replace the piston or rebore the cylinders to fit oversize pistons.
5. If the piston is replaced, the piston rings must also be replaced.